Call Us Today!
Springwood is one of the larger lower-mountains towns, an established centre with homes spread across ridges and gullies deep in the bush. The 2013 fires through this part of the mountains made the lesson plain: houses go to embers finding a gap, not to the fire front. Much of the suburb is mapped bush fire prone, so roofing work must meet AS 3959 at the assessed attack level.
Those gaps live on the roof: ridge and hip lines, valleys, eaves, vents, skylights and above all the gutters. We work across the mountains and build each Springwood roof to the BAL its assessment sets.
Across Springwood's ridges and gullies, valleys fill with leaf and bark and rust through, so valley replacement leads the repairs, with cracked capping and wind-lifted ridge tiles beside it. The second kind is a compliance gap, sealing opened by a later penetration. We fix the leak and, on mapped land, rebuild the ember protection.
A Springwood re-roof is dictated by its BAL. BAL-29: non-combustible covering, sarking, all gaps over 2 mm sealed. BAL-40: fire-rated sarking, sub-2 mm metal mesh, rated penetrations. BAL-FZ: tested systems only. We determine the level and quote and build to it, removal and disposal included.
With bush through the gullies, Springwood gutters pack with dry eucalypt debris, and mesh over a full gutter is fuel at the eaves. Maintenance is fire prevention here: we clear gutters and valleys, confirm mesh and sealing are intact, and repoint capping before each fire season.
Rebuilds, extensions and studios in Springwood get their bushfire detailing from the frame, because sarking, sealing, penetrations and mesh resist retrofitting. We work with your builder and the bushfire report so the roof passes inspection first time.
A Springwood report keeps condition and compliance apart: tile, sheeting, valley and capping life, then sarking, sealing, vent and penetration protection and mesh against the BAL. Photographs, ratings and a pre-fire-season to-do list.
The gutter is the most important bushfire component on a Springwood roof and the most overlooked. AS 3959 calls for non-combustible metal mesh, sub-2 mm at higher levels, not meltable plastic. We fit compliant mesh, renew rusted gutters, correct falls and set up easy access so it stays clear.
Bushfire-compliant roofing is detail work. A 3 mm gap at a ridge, a plastic vent cowl, an unrated skylight or mesh of the wrong aperture each undo an otherwise compliant Springwood roof. We install to what AS 3959 requires at each level and can explain which requirement drove which line in the quote.
Steep bush blocks, long driveways, sloping sites and brittle older tile make Springwood roofs demanding to work on safely. Access is assessed before we quote, and every job runs with edge protection and anchor points for the pitch. Our crew is working-at-heights certified and fully insured.
Compliant bushfire roofing needs specific products. For Springwood we source AS 3959 non-combustible metal gutter and valley mesh, sarking with the required flammability index, fire-rated sealants, rated penetration and skylight systems, and the full Colorbond range, so compliance is straightforward rather than a string of substitutions.
The cheapest Springwood roofing decision is keeping the gutters clear; the most expensive is a non-compliant detail nobody noticed. Plastic guard is cheaper than metal mesh until the moment it matters, and deferred valley replacement costs several times a clean-out. We tell you plainly what is compliance, what is maintenance, and what can wait.
Ridge-and-gully cottages and larger family homes across Springwood. Tile repairs, rebedding and repointing, valley renewal, re-roofs in tile or Colorbond, gutter replacement, and bushfire roof-and-gutter systems to the assessed BAL. Written scope and fixed pricing first.
Schools, halls, consulting rooms, shops and small industrial buildings around Springwood's centre. We schedule around opening hours, manage occupied-site access, and on mapped land specify roofing and gutter protection to the attack level, with committee documentation.
Springwood storms bring branches and whole limbs down, and a limb through tile opens a house quickly. We repair storm, tree and leak damage, complete the permanent fix, reinstate disturbed bushfire detailing, and photograph it for your insurer.
Tile is common on older Springwood homes and, non-combustible, counts for it. The weak spots are the ridge, valley and eave gaps embers use once bedding goes or sarking is absent. We repoint with flexible compound, replace tiles from matched stock, renew valley irons and seal the junctions.
Colorbond is the straightforward pick on a bushfire-prone Springwood block: non-combustible, near-gapless, and clean to pair with sarking, sealed penetrations and metal mesh. Lighter than tile for re-roofing, and better at shedding gully canopy litter.
Flat and low-slope roofs on Springwood extensions, carports and studios trap litter under canopy, a drainage and ember problem on mapped land. We install membrane or low-pitch metal with genuine falls and accessible outlets and seal upstands and penetrations to the assessment.
We start with a detailed consultation and roof inspection. Our team reviews your needs, assesses the roof condition, and clearly explains possible solutions.
You’ll receive a transparent proposal with recommended solutions, material options, and a clear timeline — no jargon, just what you need to decide.
Once approved, our licensed team completes the work according to the scheduled timeline. Most roof replacements finish within 3–7 days, with quality and safety at the core.
After finishing, we inspect the roof with you, ensure everything meets expectations, and leave your site spotless. We also share tips for ongoing care.
Our Managing Director, Tom Stephens, brings over two decades of roofing expertise. Every project benefits from this leadership, ensuring work is completed to the highest standard.
We are fully licensed and insured, with all trades carrying certifications in working at heights, asbestos awareness, and elevated work platforms. Safety is never compromised.
Winners of the Australian Small Business Champion Awards 2024 and recognised finalists in local business awards, we are proud of our industry recognition.
We back our work with a two-year workmanship guarantee, an additional five years for new builds and replacements, plus manufacturer warranties on all materials.
Tomkat Roofing has spent over twenty years on roofs across Sydney and the Blue Mountains, including bushfire-prone properties in Springwood where the roof detailing is what stands between a house and an ember shower. We are a licensed, insured team and winners of the 2024 and 2025 Australian Small Business Champion Awards in the roofer category.
Every job starts with a proper inspection and ends with a written scope and fixed pricing. Where a requirement comes from AS 3959 rather than from us, we say so and point to the clause it comes from.
Signs like leaks, sagging, missing tiles, or water stains often indicate the need for repair. However, if your roof is over 20 years old or has widespread damage, a full replacement may be more cost-effective.
Yes, we are fully licensed and insured, giving you confidence that all work is carried out to Australian standards and safety regulations. Our team is committed to delivering high-quality roofing services.
The timeline depends on the size and complexity of the roof, weather conditions, and the materials used. Most residential roof replacements take between 2 to 5 days. We’ll provide a clear timeline before the work begins.
Absolutely. We stand by the quality of our materials and workmanship. All our roofing work comes with a workmanship guarantee, and we use materials that are backed by manufacturer warranties.
© 2026 Tomkat Roofing. All Rights Reserved.
